Pictures of the neck jig. I'm finally back to working on it!!!!

OK, I'm done with the 3 guitar repairs.  Lots to do on each of them but it is now done.  So back to the neck jig project.  As I said before, I don't recall where I saw a pic of this device or even know how close I am to the original design.  I think everything that I would need for it to work has been incorporated, but then again.....who knows until I try it.  So here it is. 

So the unshaped neck gets attached to the underside of the structure.  The screws will attach to the neck where the truss rod channel will be routed out after the fact.

It's off centered because the mitre slots on the table saw are not an equal distance from the dado blade on each side.  I still have to add the sides of the unit to what you see here .  These sides will be what slides in the mitre slots.  Well I was just about to go and add the sides but my wife just brought me a huge bowl of ice cream.  And The big bang theroy is on in 20 mins......Oh well, tomorrow?